Standby Interface

After initialization, itЎЇll into the standby interface, show as:

Fig. 5-3

The top of the interface shows the file name, network status, the date and time. The white area shows the preview of the selected file. And the yellow area shows the complete times, default power, speed of the machine., the water protect status, the speed of key moving, and the position of axis x and axis y. And at the bottom left of the interface, it show the machine status and the last working time.

The parameters are described below:

l Network status: If connect the network, itЎЇll show the IP address196.168.0.100. Otherwise, it shows Network disconnect.

l Complete: The complete times of the selected file.

l Power: Power1 is default value of the laser 1 saved in the machine. The upper number is the min power, the lower value is max power. Power2 is default value of the laser 2 saved in the machine. When you click the default check box in CorelDRAW of CAD Output software in Parameters Setting page, these powers are the file work power.

l Speed: Speed is default value of the speed saved in the machine. When you click the default check box in CorelDRAW of CAD Output software in Parameters Setting page, this speed is the file work speed.

l Valid: The water protection status. In the figure, the water protection is 1X: 2X, 1X means water protection 1 not connected, 2X means water protection 2 not connected. If connect, itЎЇll show 1V: 2V.

l Key Speed: Manually move axis speed, can press the Ў°SelectЎ± key to change the speed, there are Ў°fastЎ±, Ў°middleЎ±, Ў°slowЎ±.

l PX, PY: The coordinate in the current place.